Connecting Power Wires

1. Connect the wires on the JAMMA harness to the wires for the power supply. You need +5V, -5V, and +12V for the Escape kit. This kit may not require all of the voltages used in your original game. Tie off any unused wires on the power supply.

2. You will notice that there is more than one wire for each voltage. You must use more than one wire, as called out in the footnotes of Table 1-2. Using more than one wire for each voltage ensures that you do not overload the edge connector and cause it to burn.

Was this article helpful?

0 0

Post a comment