C installation requirements

This game is shipped for operation at 110 VAC, 50/60 Hz. However, the power supply has four voltage-selection plugs that allow for the use of four different voltage ranges. Therefore, if your line voltage is 220 VAC, plug in the red plug. (See Figure 1-2)

1. Low Voltage Problems

If your game is set for 110 VAC (or 220 VAC) and your line voltage is usually below 100 VAC (or 200 VAC), you may experience a decrease in the si2e of the monitor picture and/or the game operation will be erratic (weird things will appear on the screen).

2. High Voltage Problems

If your game is set for 95 VAC (or 210 VAC) and your line voltage ¡s usually above 110 VAC (220 VAC), the monitor picture size will increase, the game will run hotter, and the game will be prone to an increase in the rate of failures.

LINE VOLTAGE

VOLTAGE-SELECTION PLUGS-WIRE COLOR

95 VAC

BLACK

110 VAC

ORANGE (installed el factory)

210 VAC

GREEN

220 VAC

RED

POWER-SUPPLY CHASSIS

POWER-SUPPLY CHASSIS

Was this article helpful?

0 0

Post a comment