Gtv monitor removal

The TV rr This is done Figure 3-5.

-CAUTION-

Hazardous or startling high voltage potential exists in any TV device, even with power disconnected. Use extreme care not to contact electrical parts on the chassis with the hands or metal objects held in the hands!!!

• Unplug the game from the wall plug

• Unlock and remove the rear access pane).

• Remove the attraction panel as described in section F of this chapter

• Lift out the cardboard bezel from its position in front of the monitor.

• Remove the four woodscrews and the two corner securing brackets.

• From the rear of the cabinet, remove the two wing nuts and two hex nuts, four lock washers and four flat washers from the carriage bolts that secure the TV monitor to its supporting shelf.

• Unplug the TV monitor connector from the back of the monitor.

• Remove the mounting bolts, and slide the monitor off of its shelf and out through thi front of the game cabinet.

lonitor may need to be removed for service, through the front of the game as shown in Proceed as follows.

After service/repairs, replace the monitor by reversing the above steps. Note that the wing nuts go on the front two bolts, and the hex nuts on the rear bolts.

RETAINING STRIP BOLTS

TV MONITOR SHELF

CARRIAGE BOLT <4)

FLAT WASHER (4) LOCK WASHER (4)

UPPER ATTRACTION PANEL RETAINING STRIP

TV MONITOR

UPPER ATTRACTION PANEL RETAINING STRIP

TV MONITOR

RETAINING STRIP BOLTS

TV MONITOR SHELF

CARRIAGE BOLT <4)

CORNER

SECURING

BRACKETS)

WOOD SCREWS (4)

CARDBOARD BEZEL

ATTRACTION PANEL

Was this article helpful?

0 0

Post a comment