Function Labels Overlay Installation

Line up the supplied function labels with the corresponding control panel holes. Remove the backing and carefully press into place. Be sure they are straight. Attach the HOOK/SWING reference diagram above the trackball label. If your control panel is too narrow to fit the reference diagram, mount the diagram under the monitor glass on the bezel. Refer to the diagrams below.

HOOK SWING Reference Overlay

\

instruction overlay face left face right overlay overlay

trackball overlay •

^ y

y

FUNCTION LABEL LAYOUT #1 (NOTE: TRACKBALL SHOULD BE CENTERED ON THE CONTROL PANEL)

FUNCTION LABEL LAYOUT #1 (NOTE: TRACKBALL SHOULD BE CENTERED ON THE CONTROL PANEL)

or put the HOOK/SWING Reference diagram on the bezel

FUNCTION LABEL LAYOUT #2

Marquee Installation:

Was this article helpful?

0 0

Post a comment