Harness

If your game does not already have a JAMMA harness, install the JAMMA harness in the cabinet. 2. Install the split beads on the harness as close to the connector as possible. Hold the beads on the harness with the tie wraps included in the kit. You must install the split beads included in the kit on the JAMMA harness to meet FCC requirements. 3. Using Table 1-3, JAMMA Pin and Wire Connections, for wiring information, connect the JAMMA harness to existing component harnesses. Use Table 1-3 JAMMA...

Assembling the Control Panel

You need the following parts from the kit to assemble the control panel Clear cover for the control panel Four start flip button collars Twelve 10-24 x 1-inch-long carriage bolts, flat washers, and locknuts 1. Measure your control panel to find out what size the decal and cover should be. Cut the control panel decal and cover to fit. 2. Clamp the control panel cover to the control panel. 3- Drill four corner holes through the control panel and the control panel cover. Use a 1 4-inch drill bit....

Illustrated Parts Lists

This chapter provides information you need to order parts for your game. Common hardware parts, such as screws, nuts, washers, and so on usually are not listed in the pans lists. The parts lists (except for the PCB parts lists) are arranged alphanumerically by Atari part number. All A-prefix numbers, which are assemblies, come first. Next are part numbers with six numbers followed by a hyphen (000598- through 201000-). Ending the list are part numbers with a two-number designation followed by a...

Troubleshooting and Maintenance

This chapter contains troubleshooting tables and repair procedures for your Klax game. The chapter has two parts. The first part contains three troubleshooting tables. The first table has general troubleshooting information, the second table contains the voltage levels and test points on the game PCB, and the last table describes ROM-caused problems with specific ROMs to check and replace. The last part of the chapter has information about connecting the video display if it requires separate...

Ig

Sit B15 RIH BIS BIZ Sil RIO B1 BB B7 Bi B5 5 NOTE USE 16L8 IF SLAPSTIK IS NOT USED. STUFF Rbl FOR MB PRRTS. STUFF R70 FOR 512K PARTS. R18 R17 Rib fll 5 Bit R13 R1Z Sll BIO + 1ZV _ (1UQX-Z flUQMP RUX2 _ RUDX-b PGND nux oudx-io Ob _ 0UDX-12 CND _ flUOX-lM- 1H _ OUDX-2i> GND _ flUOX-28 SINT _ OUDX-30 GND _ OUDX-32 S-TEST _ flUDX-3H GND _ flUDX-3b flUDRtS _ flUOX-38 +5V _ OUDX-tO CtO lC50 J-C2b lC27 .1 T-l T -1 T -1 T -LNK8 -LNK7 -LNK6 -LNK5 -LNK -LNK3 -LNK2...