276 Power Supply Adjustments

VOLTAGE Adjust voltages on +5V and +12V for + 5.00V to

CURRENT LIMITER Adjust control (51 and 121) counterclockwise until voltage just changes, then turn control clockwise until voltage goes back to original value with pointer, mark position of arrow on potentiometer then turn control until beginning of 1st notch is aligned with the pointer. On the controls with the Blue Disk turn approximately 30°.

FIGURE 2-7 CURRENT LIMIT ADJUSTMENT

NOTE: If Voltage adjustment will not bring voltage up, set current limit adjustment to V2 value.

Was this article helpful?

0 0

Post a comment