534 Connecting to the Speaker

Connect the product to the speaker(s) of your cabinet in the following procedure so that the cabinet outputs the sound.

First check whether your cabinet has one speaker (monaural) or two speakers (stereo).

D Turn OFF the power switch of the cabinet and unplug the power cord from an electrical outlet.

El Conduct a measure to prevent short-circuit, for instance, wrap the edge of the unused wire (A1, B1) of the extended edge harness with insulating tape.

B After completing all the following connection, switch to "MONAURAL" in the test mode (Ref. "6-4 SOUND TEST" p.36).

• "5-2 Installing the PC Board on the Install Board of the Cabinet (p. 11)

• "5-3-1 Checking the JAMMA Edge Connector (p. 13)

• "5-3-2 Checking the Extended Edge Connector (p. 14)

• "5-3-3 Connecting to the Control Panel (p. 15)

• "5-3-5 Connecting to the Connectors (p. 17)

• This product is set as stereo spec, as the factory-setting. When used as stereo spec, with the cabinet of the monaural spec., only the left speaker outputs the sound.

D Turn OFF the power switch of the cabinet and unplug the power cord from an electrical outlet.

B Connect the wires of the terminals A1 and B1 of the extended edge harness to the right side (R) speaker by soldering or fixing an applicable crimp-style terminal in accordance with the following table.

Was this article helpful?

0 0

Post a comment