3

You may wish to remove the "WILD WESTERN"™ Printed Circuit Boards for servicing. Refer to Figure 6.

The "WILD WESTERN" Printed Circuit Boards are located on the inside of the Rear Service Door for easy access.

To remove the boards the following steps should be followed:

1. Open the rear service door, the power will automatically be removed by the Interlock Switch located on the inside of the door frame.

2. Disconnect the connector G, H, and T from the boards.

3. Loosen and turn the Stop Bracket and pull the boards toward you out of the board guides.

Was this article helpful?

0 0

Post a comment